Brompton Bicycle Owner's Manual download pdf (Page 20)

CTN

SL2

SL1

CTW

fig AR8

itting the rear wheel.

erailleur is fitted, it has to be tilted to clear the changer).

ays to release, or else

need to prise them out with a small screw-driver.

the chain passes round the rear sprocket. Drop the axle

r hub-gears, the tab-washers TA must be in place, and the

t, SL1,

nd do up the wheel nuts, torque 22NM.

ng true over both chainwheel and

sprocket): next note that the chain

er f hese should pass either

ate when fitting the chain tensioner:

hain tensioner to the axle plate

ain passes between the fixed idler

Removing the rear wheel, fig AR8.

Slacken the axle mounting nuts. For hub gears at least 4 or 5 turns are

needed, so that the tab-washers TA can disengage from their slots, SL2: if

these are stuck in place, try rocking the wheel sidew

you may

Make sure that

into the slots: fo

correct way round (i.e. tabs marked “TOP” aligned with slots SL2). Make

sure that each end of the axle is seated against the end of the slo

Fitting the chain tensioner:

First arrange the chain so that it is runni

rear sprocket (for a derailleur, the outer

tensioner body has two flanges on its inn

side of the axle pl

ace - t

a) for a non-derailleur bike, address the c

and press home, making sure that the ch

sprocket CTIDL and the rear sprocket.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

No comments

Brompton Bicycle Owner's Manual Page 20